150 - 800 GPD


Compact II (Front)

Compact II (Back)

STANDARD FEATURES:
   
•

Thin film composite membrane
•

PVC membrane housing
•

Power-coated steel bracket
•

Inlet and outlet pre-filter gauges
•

Liquid-filled system pressure gauge
• Pressurized tank pressure gauge
• Adjstbl. waste/recycle needle valves
•

High-pressure nylon tubing
•

High-pressure brass comp. fittings
•

Storage tank pressure switch
•

Low-pressure switch
•

Feedwater inlet solenoid valve
•

1/2 hp 50/60 hz motor
•

Rotary vane pump
•

20" 5 micron sediment pre-filter (1)
•

20" carbon block pre-filters (2)
•

Salt rejection 95 - 99%

Options:

Float switch for atmospheric storage tank
Stainless steel pump
Stainless steel membrane housing
Fiberglass panel for wall mount design
Automatic hourly flush
Manual flush
220 volt motor
Stainless steel needle valves
Additional pre-treatment, see below:

The pre-filtration on the COMPACT is sufficient for the 150 and 250 gpd models. It is advisable that additional pre-treatment be installed in front of the COMPACT for the 450 and 800 gpd models. Higher volumes of water passing through the COMPACT can shorten membrane life.




FEED WATER PARAMETERS:
Temperature 85°F maximum Pressure 40 - 80 psi maximum TDS 2000 ppm maximum. If higher, consult factory Iron tolerence 0.5 ppm maximum Hydrogen sulfide must be removed Silica tolerance can not be higher than 125 ppm in the concentrate stream. Anti-scalant should be considered for any levels over 75 ppm. Turbidity should be removed Hardness over 10gpg should be softened.

OPERATING PARAMETERS:
Operating pressure 200 psi maximum Water recov-ery is facotry set at 33 - 35% pH range 3 - 11
Flow rates are determined by the membrane mfgr's. testing criteriea of 1500 ppm Nacl solution, 77F water temperature, 225 psi at 10 - 15% recovery. Actual flow rates may vary depending on the pre-treatment used, water conditions, system size and applied pressure.

MODEL
GPD
MEMBRANE
PIPING
DIMENSIONS
       
inlet
waste
prod
    
COM-II 150
150
2.5" x 14"
1 ea.
3/8"
3/8"
3/8"
14" x 16" x 30"H
58 lbs.
COM-II 250
250
2.5" x 21"
1 ea.
3/8"
3/8"
3/8"
14" x 16" x 30"H
61 lbs.
COM-II 450
450
4" x 14"
1 ea.
3/8"
3/8"
3/8"
14" x 16" x 30"H
65 lbs.
COM-II 800
800
4" x 21"
1 ea.
1/2"
3/8"
3/8"
14" x 16" x 30"H
68lbs.

mail us