10,000 - 23,000 GPD

STANDARD FEATURES:     • Power-coasted steel frame • Stainless steel high-pressure multi-stage pump • Thin film composite membrane • 80" PVC membrane housing • Liquid-filled pre/post filter press. gauges • Liquid-filled feed & conc. press. gauges • Liquid-tight wire shrouding • Motorized inlet ball valve • Adjustable s. s. concentrate valve • Product & waste flow meters • Product sampling valves for each vessel • 20" 5 micron pre-filters (2) • Victaulic couplings on membrane manifolding • Stainless steel throttling valve • Fused main disconnect switch • Alumninum diamond plate on skid base • Low voltage dual-level product switches • Automatic hourly fast flush • Optimum performace membrane array	• NEMA 4 fiberglass enclosure • Off/On switch • Dual level float switches • Low pressure switch • Low pressure bypass delay • Fused control circuit • 24 volt level control circuit • Time delay start • IEC motor contactor w/overload relay • High pressure cut-out w/auto restart • High pressure instant start reset button • Solid state hourly fast flushing timer • Digital TDS monitor (1 - 99 ppm range) • Pre-treatment backwash or regenerating lock-out Frame Mount Horizontal
Lights: power, running, flushing, low pressure, high pressure, tank full, pre-treatment lock-out, high pressure

FEED WATER PARAMETERS: Temperature 85°F maximum Pressure 40 - 80 psi maximum TDS 2000 ppm maximum. If higher, consult factory Iron tolerence 0.5 ppm maximum Hydrogen sulfide must be removed Silica tolerance can not be higher than 125 ppm in the concentrate stream. Anti-scalant should be considered for any levels over 75 ppm. Turbidity should be removed Hardness over 10gpg should be softened. OPERATING PARAMETERS: Operating pressure 200 psi maximum Water recov-ery is facotry set at 33 - 35% pH range 3 - 11 Flow rates are determined by the membrane mfgr's. testing criteriea of 1500 ppm Nacl solution, 77F water temperature, 225 psi at 10 - 15% recovery. Actual flow rates may vary depending on the pre-treatment used, water conditions, system size and applied pressure.

OPTIONS: Stainless steel membrane Fiberglass membrane housing Stainless steel manifolding pH monitor control Higher operating pressures Higher product flow output Membrane cleaning ports Chemical or antisclant injection 50 hz electrical requirement Shipping crate Other options available upon request

MODEL	GPD	MEMBRANE		MOTOR	PIPING			DIMENSIONS
					inlet	waste	prod
FMH 3 - 2	9000 - 10800	4" x 40"	6 ea.	5 HP	1 ½"	1"	1"	32" x 108" x 60"H
FMH 4 - 2	12000 - 14400	4" x 40"	8 ea.	5 HP	1 ½"	1"	1"	32" x 108" x 60"H
FMH 5 - 2	15000 - 17400	4" x 40"	10 ea.	7.5 HP	1 ½"	1"	1"	32" x 108" x 60"H
FMH 6 - 2	18000 - 20000	4" x 40"	12 ea.	7.5 HP	1 ½"	1"	1"	32" x 108" x 60"H
FMH 7 - 2	21000 - 23000	4" x 40"	14 ea.	7.5 HP	1 ½"	1"	1"	32" x 108" x 60"H